In 1927 the first precursor of IMTS was held in Cleveland. Back then, lasers, robots and computer controls were just science fiction. At IMTS 98 they will fill nearly every last corner of the recently expended McCormick Place.
Come with us now to those thrilling days of yesteryear...Ok, this is not the Cisco Kid, but we do have a little game for you. Guess the year the following advertisements and excerpt were printed - they all appeared in a dingle issue of Machinery Magazine.
ISO 6336 Calculation of Load Capacity of Spur and Helical Gears was published in 1997 after 50 years of effort by an international committee of experts whose work spanned three generations of gear technology development. It was a difficult compromise between the existing national standards to get a single standard published which will be the basis for future work. Many of the compromises added complication to the 1987 edition of DIN 3990, which was the basic document.
It should be obvious by now that gears are more than just mechanical components. We have brought you movies with gears and Shakespeare with gears, jewelry made out of gears and so on. Now we, the humble staff at Addendum, are proud to present gears in the world of music.
The American Gear Manufacturers Association (AGMA) is accredited by the American National Standards Institute (ANSI) to write all U.S. standards on gearing. However, in response to the growing interest in a global marketplace, AGMA became involved with the International Standards Organization (ISO) several years ago, first as an observer in the late 1970s and then as a participant, starting in the early 1980s. In 1993, AGMA became Secretariat (or administrator) for Technical Committee 60 of ISO, which administers ISO gear standards development.
The wind turbine industry has been plagued with gearbox failures, which cause repair costs, legal expenses, lost energy production and environmental pollution.
Happy days are here again, says the old song, and given the current economic numbers, one can scarcely argue. Productivity is up; unemployment is down; inflation is practically nonexistent; the budget deficit is shrinking fast.
Heat treating is a critical operation in gear manufacturing. It can make or break the quality of your final product. Yet it is one that frequently gear manufacturers outsource to someone else. Then the crucial question becomes, how do you know you're getting the right heat treater? How can you guarantee your end product when you have turned over this important process to someone else?