AGMA's Gear Expo '91, "The World of Gearing," opens Oct. 20-23 at Cobo Conference & Exhibition Center, Detroit, MI. Gear Expo '91 will provide 35,000 square feet of exhibits by 91 companies from around the world.
Dictatorships can be stifling. In an autocratic organization, employees seldom participate in decisions that affect them. By establishing a collaborative environment, you allow everyone to play a role in making your organization a success.
AGMA's Gear Expo '91, "The World of Gearing," opens October 20 and runs through October 23 at the Cobo Conference & Exhibition Center in "The Heart of the Manufacturing Industry," Detroit, MI. Gear Expo '91 is "the largest trade show ever specifically organized for the gear industry," according to Rich Norment, AGMA's Executive Director.
Spur gear endurance tests were conducted to investigate the surface pitting fatigue life of noninvolute gears with low numbers of teeth and low contact ratios for the use in advanced application. The results were compared with those for a standard involute design with a low number of teeth. The gear pitch diameter was 8.89 cm (3.50 in.) with 12 teeth on both gear designs. Test conditions were an oil inlet temperature of 320 K (116 degrees F), a maximum Hertz stress of 1.49 GPa (216 ksi), and a speed of 10,000 rpm. The following results were obtained: The noninvolute gear had a surface pitting fatigue life approximately 1.6 times that of the standard involute gear of a similar design. The surface pitting fatigue life of the 3.43-pitch AISI 8620 noninvolute gear was approximately equal to the surface pitting fatigue life of an 8-pitch, 28-tooth AISI 9310 gear at the same load, but at a considerably higher maximum Hertz stress.
Five years of effort by AGMA came to fruition in January with the publishing of a report from the Department of Commerce. This "National Security Assessment of the U.S. Gear Industry" indicates that if serious measures are not taken, the gear industry's future is in jeopardy. It also sets the tone for confronting major challenges now looming large in our industry.
Bankruptcy filings have not noticeably declined despite the economic recovery of the Reagan years. Businesses continue to receive notices that their customers have filed bankruptcy. Many of them are writing off significant losses each year as a result. despite the frequent use of bankruptcy by debtors, many business owners and managers have little or no idea of the pot-bankruptcy remedies available to them.
The quality of gearing is a function of many factors ranging from design, manufacturing processes, machine capability, gear steel material, the machine operator, and the quality control methods employed. This article discusses many of the bevel gear manufacturing problems encountered by gear manufacturers and some of the troubleshooting techniques used.
Countless research studies confirm this fact: Companies that advertise aggressively during a recession will flourish after the economic tide turns. Regardless of company size, effective advertising generally requires the services of an agency, and under current economic conditions, you may need one now more than ever. The question is, how do you go about getting the right one for your company.
In Part I differences in pitting ratings between AGMA 218, the draft ISO standard 6336, and BS 436:1986 were examined. In this part bending strength ratings are compared. All the standards base the bending strength on the Lewis equation; the ratings differ in the use and number of modification factors. A comprehensive design survey is carried out to examine practical differences between the rating methods presented in the standards, and the results are shown in graphical form.