October/November 1984

Notes from the Editor's Desk

History comes around full circle. It is interesting to talk to gear manufacturers who service the defense, aerospace, automotive and computer industries and find that their sales, production and backlogs reflect excellent and, in some cases, record breaking business.

Single-Flank Testing

It was very interesting to see Robert Smith's article on single-flank testing of gears...

Endurance Limit for Contact Stress in Gears

With the publishing of various ISO draft standards relating to gear rating procedures, there has been much discussion in technical papers concerning the various load modification factors. One of the most basic of parameters affecting the rating of gears, namely the endurance limit for either contact or bending stress, has not, however, attracted a great deal of attention.

Cone Drive Double Enveloping Worm Gearing Design and Manufacturing

Worm gearing is of great antiquity, going back about 2100 years to Archimedes, who is generally acknowledged as its inventor. Archimedes' concept used an Archimedial spiral to rotate a toothed wheel. Development of the worm gearing principle progressed along conventional lines until about 500 years ago when Leonardo DaVinci evolved the double enveloping gear concept.

Gear Generating Using Rack Cutters

Universal machines capable of cutting both spur and helical gears were developed in 1910, followed later by machines capable of cutting double helical gears with continuous teeth. Following the initial success, the machines were further developed both in England and France under the name Sunderland, and later in Switzerland under the name Maag.

Scoring Load Capacity of Gears Lubricated with EP-Oils

The Integral Temperature Method for the evaluation of the scoring load capacity of gears is described. All necessary equations for the practical application are presented. The limit scoring temperature for any oil can be obtained from a gear scoring test.

Austempered Ductile Iron: Technology Base Required for an Emerging Technology

This paper addresses Austempered Ductile Iron (ADI) as an emerging Itechnology and defines its challenge by describing the state-of-the-art of incumbent materials. The writing is more philosophical in nature than technical and is presented to establish a perspective.

Design of Involute Gear Teeth

In designing involute gear teeth, it is essential that the fundamental properties of the involute curve be clearly understood. A review of "the Fundamental Laws of the Involute Curve" found in last issue will help in this respect. It has previously been shown that the involute curve has its origin at the base circle. Its length, however, may be anything from zero at the origin or starting point on to infinity. The problem, therefore, in designing gear teeth, is to select that portion of the involute, which will best meet all requirements.

...And from the Industry

Industry News from October/November 1984 Gear Technology.

Technical Calendar

The complete Technical Calendar from the October/November 1984 issue of Gear Technology