Contact fatigue and bending fatigue are two main failure modes of steel gears, while surface pitting and spalling are two common contact fatigue failures -- caused by alternating subsurface shear stresses from the contact load between two gear mates. And when a gear is in service under cyclic load, concentrated bending stresses exist at the root fillet -- the main driver of bending fatigue failures. Induction hardening is becoming an increasingly popular response to these problems, due to its process consistency, reduced energy consumption, clean environment and improved product quality -- but not without issues of its own (irregular residual stresses and bending fatigue). Thus a new approach is proposed here that flexibly controls the magnitude of residual stress in the regions of root fillet and tooth flank by pre-heating prior to induction hardening. Using an external spur gear made of AISI 4340 as an example, this new concept/process is demonstrated using finite element modeling and DANTE commercial software.

This paper presents an original method for computing the loaded mechanical behavior of fiber reinforced polymer gears. Although thermoplastic gears are unsuitable for application transmitting high torque, adding fibers can significantly increase their performance. The particular case of polyamide 6 + 30% glass fibers is studied in this paper.

Can my metal gear(s) be replaced with plastic gears?

[starbox] If ever a situation cried out for a short, texting-friendly acronym it is the unavoidable problem of “You don’t know what you don’t kn...

[starbox] There is a new commercial airing that shows flashbacks of a young girl enjoying a family road trip from the rear facing seat in their ...

The complete Industry News section from the May 2014 issue of Gear Technology.

Tiger stripes on a high-speed pinion made of a carburized SAE 9310 steel were investigated. The morphology of the damage was typical of electric discharge damage. The cause of the stripes and potential damage to the gear tooth were analyzed and are presented in this report.

[starbox] Estimating is a necessary evil in every shop. Nobody wants to do it, but if it doesn’t get done there is no business. Fortunately, we ...

[starbox] I have been hearing a lot about 3-D printing and how it will revolutionize manufacturing in the United States. Millions are slated to ...

[starbox] It is only April 2nd, but I can already predict that local TV cameras will have the post office staked out 13 days from now as thousan...